Got my side vents glued into place. I’m using a set of mount studs from McMaster Carr. I used some structural adhesive to bond them in, aligning the louvers and using tie-wraps and sticks to hold them in place.
I’ll take em apart tomorrow and start painting the louvers so we can get this stuff back together for good.
The next steps will be to install the exhaust with the Breeze angle plates that are on order, install the vents after they’ve been painted and buffed, then install the wheelwell splash guards and paint them and parts of the inside of the wheel well with the bedliner.
No picture, but finished assembling and riveting the aluminum panels that fit under the doors in the interior. Tomorrow I’ll get em covered and trimmed out.